Cisco Catalyst 4500 Series Configuration Manual page 958

show netflow-lite sampler
show netflow-lite sampler
NetFlow-lite is only supported on the Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
Note
To display information about a sampler, use the show netflow-lite sampler command.
Syntax Description
sampler-name
Command Default This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
15.0(2)SG
Examples The following example shows how to display information about a sampler,:
Switch# show netflow-lite sampler low-rate
Netflow-lite Sampler low-rate:
Description:
Sampling rate:
Packet Section Size:
Packet offset:
Related Commands Command
packet-section size (netflow-lite
sampler submode)
packet-rate (netflow-lite
sampler submode)
packet-offset (netflow-lite
sampler submode)
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-910
show netflow-lite sampler sampler-name
Specifies a sampler name.
Modification
Command introduced on the Catalyst 4500 series switch.
Sampler
1 out of 256
64 bytes
0 bytes
Description
Specifies a sampled header size in netflow-lite submode.
Specifies a packet sampling rate in netflow-lite sampler submode.
Specifies a starting packet offset in netflow-lite submode.
Chapter 2
OL-30934-01