Cisco Catalyst 4500 Series Configuration Manual page 688

service-policy (interface configuration)
Service-policy input: p1
The following example shows how to attach a policy map to a VLAN using a Supervisor Engine 6-E:
Switch# configure terminal
Switch(config)#vlan configuration 20
Switch(config-vlan-config)#service-policy out policy-vlan
Switch(config-vlan-config)#end
Switch#
Related Commands Command
class-map
policy-map
service-policy (interface
configuration)
show policy-map interface
vlan
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-648
Class-map: class-default (match-any)
0 packets
Match: any
0 packets
police: Per-interface
Conform: 0 bytes Exceed: 0 bytes
Description
Creates a class map to be used for matching packets to the class
whose name you specify and to enter class-map configuration
mode.
Creates a policy map that can be attached to multiple ports to
specify a service policy and to enter policy-map configuration
mode.
Attaches a policy map to an interface.
Displays the QoS policy-map information applied to a specific
VLAN on an interface.
Chapter 2