Cisco Catalyst 4500 Series Configuration Manual page 568

object-group
Syntax Description network
service
object-group-name
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-528
Defines network object groups for use in object-group-based ACLs. When
you configure the object-group network command, the command mode
changes to network group configuration mode.The following options are
available in this mode:
A.B.C.D Network address of the group members
description Network object group description
execute Execute a shell function
exit Exit from object group configuration mode
group-object Nested object group
host Host address of the object-group member
no Negate or set default values of a command
Defines service object groups for use in object-group-based ACLs.
<0-255> An IP protocol number
ahp Authentication Header Protocol
description Service object group description
eigrp Cisco's EIGRP routing protocol
esp Encapsulation Security Payload
execute Execute a shell function
exit Exit from object-group configuration mode
gre Cisco's GRE tunneling
group-object Nested object group
icmp Internet Control Message Protocol
igmp Internet Gateway Message Protocol
ip Any Internet Protocol
ipinip IP in IP tunneling
no Negate or set default values of a command
nos KA9Q NOS compatible IP over IP tunneling
ospf OSPF routing protocol
pcp Payload Compression Protocol
pim Protocol Independent Multicast
tcp Transmission Control Protocol
tcp-udp TCP or UDP protocol
udp User Datagram Protocol
Name of the object group (of type service or network).
The object group name is a sequence of 1 to 64 characters consisting of
letters, digits, underscores (_), dashes (-), or periods (.). The
object-group-name must start with a letter.
Chapter 2