Cisco Catalyst 4500 Series Configuration Manual page 727

Chapter 2
show auto security
To display the auto security (configuration), use the show auto security command.
Syntax Description
configuration
Command Default This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
3.6.0E
Examples The following example shows the output of the show auto security command when AS is disabled
globally:
Switch# show auto
Auto Secure is Disabled globally
AutoSecure is Enabled on below interface(s):
--------------------------------------------
none
Switch#
The following example shows how to enable auto security on an uplink port:
Switch# conf t
Enter configuration commands, one per line.
Switch(config)# int g1/0/15
Switch(config-if)# auto security-port uplink
Switch(config-if)# end
Switch# sh auto security
Auto Secure is Enabled globally
AutoSecure is Enabled on below interface(s):
--------------------------------------------
GigabitEthernet1/0/2
GigabitEthernet1/0/3
GigabitEthernet1/0/15
The following example shows how to enable auto security on an access port:
Switch# conf t
Enter configuration commands, one per line.
Switch(config)# int g1/0/18
Switch(config-if)# auto security-port host
Switch(config-if)# end
Switch#
Apr
show auto security [configuration]
Displays the CLIs that are applied with AS.
Modification
This command was introduced on the Catalyst 4500 series switch.
security
5 22:16:41.725: %SYS-5-CONFIG_I: Configured from console by consolesh auto security
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
End with CNTL/Z.
End with CNTL/Z.
show auto security
2-679