8A)Ew; 19)Ew; Usage Guidelines You Can Also Use The; This Command Has No Default Settings - Cisco Catalyst 4500 Series Configuration Manual

show ip igmp snooping mrouter

show ip igmp snooping mrouter
To display information on the dynamically learned and manually configured multicast switch interfaces,
use the show ip igmp snooping mrouter command.
Syntax Description vlan vlan-id
Command Default

This command has no default settings.

Command Modes Privileged EXEC mode
Command History Release

12.1(8a)EW

12.1(19)EW

Usage Guidelines You can also use the

address table for a VLAN that has IGMP snooping enabled.

You can display IGMP snooping information for the VLAN interfaces by entering the show ip igmp
interface vlan vlan-num command.
Examples The following example shows how to display snooping information for a specific VLAN:
Switch# show ip igmp snooping mrouter vlan 1
vlan
-----+----------------------------------------
1
Switch#
Related Commands Command
ip igmp snooping vlan mrouter
show ip igmp interface

show mac-address-table multicast

Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-788
show ip igmp snooping mrouter [vlan vlan-id]
(Optional) Specifies a VLAN; valid values are from 1 to 1001 and from 1006 to 4094.

Modification

This command was introduced on the Catalyst 4500 series switch.

Added support for extended VLAN addresses.
show mac-address-table multicast
ports
Gi1/1,Gi2/1,Fa3/48,Switch
command to display entries in the MAC
Description
Statically configures a Layer 2 interface as a multicast
router interface for a VLAN.
Displays the information about the IGMP-interface status
and configuration.
Displays information about the multicast MAC address
table.
Chapter 2
OL-30934-01