Destination Address - Cisco Catalyst 4500 Series Configuration Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

destination address

To configure the destination e-mail address or URL to which Call Home messages will be sent, use the
destination address command.
Syntax Description email email-address
http url
Command Default This command has no default settings.
Command Modes cfg-call-home-profile
Command History Release
12.2(52)SG
Usage Guidelines To enter profile call-home configuration submode, use the profile command in call-home configuration
mode.
When entering the https:// destination URL for the secure server, you must also configure a trustpoint
CA.
Examples The following example shows how to set the destination to the e-mail address callhome@cisco.com:
Switch(config)# call-home
Switch(cfg-call-home)# profile cisco
Switch(cfg-call-home-profile)# destination address email callhome@cisco.com
Related Commands Command
destination message-size-limit bytes
destination preferred-msg-format
destination transport-method
profile
subscribe-to-alert-group all
subscribe-to-alert-group configuration
subscribe-to-alert-group diagnostic
destination address {email email-address | http url}
Specifies the destination e-mail address in 1 to 200 characters.
Specifies the destination HTTP URL in 2 to 200 characters.
Modification
This command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Description
Configures a maximum destination message size for the
destination profile.
Configures a preferred message format.
Enables the message transport method.
Enters profile call-home configuration submode
Subscribes to all available alert groups.
Subscribes this destination profile to the Configuration
alert group.
Subscribes this destination profile to the Diagnostic alert
group.
destination address
2-197