Cisco Catalyst 4500 Series Configuration Manual page 136

class
Related Commands Command
bandwidth
class-map
dbl
police
police (percent)
police rate
policy-map
priority
service-policy (interface
configuration)
service-policy (policy-map
class)
set
shape (class-based queueing)
show policy-map
trust
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-98
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Specifies or modifies the minimum bandwidth provided to a class
belonging to a policy map attached to a physical port.
Creates a class map to be used for matching packets to the class
whose name you specify and to enter class-map configuration
mode.
Enables active queue management on a transmit queue used by a
class of traffic.
Configures the Traffic Policing feature.
Configures traffic policing on the basis of a percentage of
bandwidth available on an interface.
Configures single- or dual-rate policer.
Creates a policy map that can be attached to multiple ports to
specify a service policy and to enter policy-map configuration
mode.
Enables the strict priority queue (low-latency queueing [LLQ])
and to give priority to a class of traffic belonging to a policy map
attached to a physical port.
Attaches a policy map to an interface.
Creates a service policy that is a quality of service (QoS) policy
within a policy map.
Marks IP traffic by setting a class of service (CoS), a
Differentiated Services Code Point (DSCP), or IP-precedence in
the packet.
Enables traffic shaping a class of traffic in a policy map attached
to a physical port.
Displays information about the policy map.
Defines a trust state for traffic classified through the class
policy-map configuration command.
OL-30934-01