Cisco Catalyst 4500 Series Configuration Manual page 615

Chapter 2
power inline logging global
To enable console messages that show when a PoE device has been detected and to show when a PoE
device has been removed, use the power inline logging global command.
Syntax Description This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Global configuration mode
Command History Release
15.0(2)SG2/
XE 3.2.2SG
Usage Guidelines
Be aware of the potential for console flooding if this command is used on a switch connected to several
PoE devices.
Examples
The following example shows how to globally enable PoE status messaging on each interface:
To enable PoE event logging, you use the logging event poe-status global command:
Switch# conf terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# power inline logging global
Switch(config)# int gigabitEthernet 5/5
Switch(config-if)# shut
Switch(config-if)#
*Oct 17 12:02:48.407: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi5/5: PD removed
Switch(config-if)# no shut
Switch(config-if)#
*Oct 17 12:02:54.915: %ILPOWER-7-DETECT: Interface Gi5/5: Power Device detected: IEEE PD
Related Commands Command
logging event link-status global (global
configuration)
power inline logging global
Modification
This command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Description
Changes the default switch-wide global link-status event
messaging settings.
power inline logging global
2-575