Cisco Catalyst 4500 Series Configuration Manual page 458

lacp port-priority
lacp rate
To set the rate at which Link Aggregation Control Protocol (LACP) control packets are received by an
LACP-supported interface, use the lacp rate command in interface configuration mode. To return to the
default settings, use the no form of this command.
Syntax Description
Command Default 30 seconds
Command Modes
Interface configuration mode
Command History Release
IOS XE 3.7.1E and IOS
15.2(3)E1
Usage Guidelines Using the lacp rate command, you can set the LACP rate to a default of 30 seconds or to the fast rate of
1 second. This command is supported only on LACP-enabled interfaces.
The following example shows how to set the lacp rate for an interface:
Examples
Switch(config)# interface gigabitEthernet 2/1
Switch(config-if)# lacp rate fast
Related Commands Command
show lacp
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-418
lacp rate {normal | fast}
no lacp rate
normal
Specifies that LACP control packets are received at the normal rate (every 30
seconds).
fast
Specifies that LACP control packets are received at the fast rate (once every 1
second).
Modification
This command was introduced.
Description
Displays LACP information.
Chapter 2