Cisco Catalyst 4500 Series Configuration Manual page 578

pagp learn-method
pagp learn-method
To learn the input interface of the incoming packets, use the pagp learn-method command. To return to
the default value, use the no form of this command.
Syntax Description
aggregation-port
physical-port
Command Default Aggregation port is enabled.
Command Modes
Interface configuration mode
Command History Release
12.1(8a)EW
Examples The following example shows how to enable physical port address learning within the bundle:
Switch(config-if)# pagp learn-method physical-port
Switch(config-if)#
The following example shows how to enable aggregation port address learning within the bundle:
Switch(config-if)# pagp learn-method aggregation-port
Switch(config-if)#
Related Commands Command
show pagp
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-538
pagp learn-method {aggregation-port | physical-port}
no pagp learn-method
Specifies learning the address on the port channel.
Specifies learning the address on the physical port within the bundle.
Modification
This command was introduced on the Catalyst 4500 series switch.
Description
Displays information about the port channel.
Chapter 2