Cisco Catalyst 4500 Series Configuration Manual page 118
Ios software configuration guide isco ios xe 3.9.0e and ios 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages)
Table of Contents
Advertisement
border
border
To configure the IP address of the fabric border device in the fabric domain, use the border ip address
command. The no border IP address command removes reference the association of the border device
from the edge device.
Syntax Description
ip address
Command Default
None.
Command Modes
Fabric-auto-domain configuration
Command History
Release
3.9.01E
Usage Guidelines
Use this command to configure the IP address of the fabric border device. Border devices in the fabric
domain connect traditional Layer 3 networks or different fabric domains to the local domain, and
translate reachability and policy (VRF and SGT) information from one domain to another.
This command auto-generates LISP configuration, to orchestrate the fabric overlay. The show-running
configuration command shows the fabric domain configuration including the auto-generated
commands.
Examples
The following configuration is auto-generated when this command is run on your device:
Device(config-fabric-auto-domain)#border 198.51.100.4
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-80
border ip address
no border ip address
Modification
This command was introduced on the Catalyst 4500-E series switch using a
Supervisor Engines 8-E and 8L-E.
ipv4 use-petr 198.51.100.4 priority 10 weight 10
Chapter 2
Cisco IOS Commands for the Catalyst 4500 Series Switches
Configures the IP address of the fabric border device.
OL-30934-01
Advertisement
Table of Contents
