Cisco Catalyst 4500 Series Configuration Manual page 780

show hw-module system max-port-num-mode
show hw-module system max-port-num-mode
To display the current mode in which a system is running as well as a message informing you that
linecards beyond the 5th slot are unsupported, use the show hw-module system max-port-num-mode
command.
Command Default none
Command Modes Privileged EXEC mode
Command History Release
Release IOS XE
3.5.0E and IOS
15.2(1)E
Usage Guidelines
The CLI shall be visible only on a 10-slot chassis or if 10-slot chassis is present in VSS.
Examples The following example shows the output of the
command on the standalone switch:
Switch# show hw-module system max-port-num-mode
Active max-port-num-mode configuration is 2
In this mode, Line cards inserted in last 3 slots (8,9 and 10) will not be active
The following example shows the output of the show hw-module system max-port-num-mode
command in switch virtual mode:
Switch1# show hw-module system max-port-num-mode
Executing the command on VSS member switch role = VSS Active, id = 1
Active max-port-num-mode configuration is 1 (Default)
Executing the command on VSS member switch role = VSS Standby, id = 2
Active max-port-num-mode configuration is 2
In this mode, Line cards inserted in last 3 slots (8,9 and 10) will not be active
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-732
show hw-module system max-port-num-mode
Modification
This command was introduced on the Catalyst 4500 series switch.
hw-module system max-port-num-mode
show
Chapter 2
OL-30934-01