Show Interfaces Transceiver - Cisco Catalyst 4500 Series Configuration Manual

show interfaces transceiver

show interfaces transceiver
To display diagnostic-monitoring data for all interfaces that have transceivers installed, use the show
interfaces transceiver command.
Syntax Description int_name
detail
module mod
Command Default
The noninterface-specific versions of the show interfaces transceiver command are enabled by default.
The interface-specific versions of these commands are enabled by default if the specified interface has
a transceiver (GBIC or SFP) that is configured for diagnostic monitoring, and the transceiver is in a
module that supports diagnostic monitoring.
Command Modes Privileged EXEC mode
Command History Release
12.1(20)EW
12.2(18)EW
Usage Guidelines The show interfaces transceiver command provides useful information under the following conditions:
•
•
If you notice that the alarm and warning flags have been set on a transceiver, reenter the command to
confirm.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-758
show interfaces {{[int_name] transceiver {[detail]} | {transceiver [module mod] | detail
[module mod]}}
(Optional) Interface name.
(Optional) Displays the calibrated values and the A2D readouts if the readout values
differ from the calibrated values. Also displays the high-alarm, high-warning,
low-warning, and low-alarm thresholds.
(Optional) Limits the display to interfaces on a specific module.
Modification
This command was introduced on the Catalyst 4500 series switch.
Support for the calibration keyword was withdrawn.
At least one transceiver is installed on a chassis that is configured for diagnostic monitoring.
The transceiver is in a module that supports diagnostic monitoring.
Chapter 2
OL-30934-01