show policy-map interface vlan
Switch#
The following example shows a configuration on a Supervisor Engine 6-E:
interface gigabitethernet3/1
vlan-range 100
service-policy in p1
The following example shows how to display policy-map statistics on VLAN 100 on the FastEthernet
interface:
Switch# show policy-map interface gigabitethernet 3/1 vlan 100
GigabitEthernet3/1 vlan 100
Service-policy input: p1
Switch#
Related Commands
Command
service-policy (interface configuration)
show policy-map interface
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-926
Class-map: c1 (match-all)
0 packets
Match: ip dscp af11 (10)
police: Per-interface
Conform: 0 bytes Exceed: 0 bytes
Class-map: class-default (match-any)
0 packets
Match: any
0 packets
Class-map: c1 (match-all)
0 packets
Match: ip dscp af11 (10)
police:
rate 128000 bps, burst 4000 bytes
conformed 0 packets, 0 bytes; action:
transmit
exceeded 0 packets, 0 bytes; action:
drop
conformed 0 bps, exceeded 0 bps
Class-map: class-default (match-any)
0 packets
Match: any
0 packets
Description
Attaches a policy map to an interface.
Displays the statistics and configurations of the input and
output policies that are attached to an interface.
Chapter 2
OL-30934-01