Cisco Catalyst 4500 Series Configuration Manual page 414

Ios software configuration guide isco ios xe 3.9.0e and ios 15.2(5)ex
Hide thumbs Also See for Catalyst 4500 Series:
Table of Contents

Advertisement

ip wccp redirect
ip wccp redirect
To enable packet redirection on an inbound or outbound interface using Web Cache Communication
Protocol (WCCP), use the ip wccp redirect command in interface configuration mode. To disable
WCCP redirection, use the no form of this command.
Syntax Description
web-cache
service-number
in
out
Command Default
Redirection checking on the interface is disabled.
Command Modes
Interface configuration (config-if)
Command History
Release
12.2(31)SG
IOS XE 3.2(0)SG
(15.0(2)SG)
15.0(2)SG1
IOS XE 3.3.0 SG
(15.1(1)SG)
Usage Guidelines
The ip wccp {web-cache | service-number} redirect in command allows you to configure WCCP
redirection on an interface receiving inbound network traffic. When the command is applied to an
interface, all packets arriving at that interface will be compared against the criteria defined by the
specified WCCP service. If the packets match the criteria, they will be redirected.
Likewise, the ip wccp {web-cache | service-number} redirect out command allows you to configure
the WCCP redirection check at an outbound interface.
Be careful not to confuse the ip wccp {web-cache | service-number} redirect {out | in} interface
Tips
configuration command with the ip wccp redirect exclude in interface configuration command.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-374
ip wccp {web-cache | service-number} redirect {in | out}
no ip wccp {web-cache | service-number} redirect {in | out}
Enables the web cache service.
Identification number of the cache engine service group; valid values are
from 0 to 254.
If Cisco cache engines are used in the cache cluster, the reverse proxy
service is indicated by a value of 99.
Specifies packet redirection on an inbound interface.
Specifies packet redirection on an outbound interface.
Modification
Support introduced on the Catalyst 4500 series switch.
Support extended to Supervisor Engine 6-E, Supervisor Engine 6L-E,
Catalyst 4900M, Catalyst 4948E, and Catalyst 4948E-F.
web-cache and service-number keywords supports on Supervisor Engine
6-E, Supervisor Engine 6L-E, Catalyst 4900M, Catalyst 4948E, and
Catalyst 4948E-F.
Supported extended to Supervisor Engine 7-E and Supervisor Engine 7L-E.
Chapter 2

Advertisement

Table of Contents
loading

Table of Contents