debug condition standby
The following example shows the display if you try to turn off the last standby debug condition:
Switch# no debug condition standby vlan 1 0
This condition is the last standby condition set.
Removing all conditions may cause a flood of debugging
messages to result, unless specific debugging flags
are first removed.
Proceed with removal? [yes/no]: n
% Operation aborted
Switch#
Related Commands
Command
undebug condition standby
(same as no debug condition
standby)
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-152
Chapter 2
Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Disables debugging output.
OL-30934-01