Show Interfaces Switchport - Cisco Catalyst 4500 Series Configuration Manual

show interfaces switchport

show interfaces switchport
To display the administrative and operational status of a switching (nonrouting) port, use the show
interfaces switchport command.
Syntax Description interface-id
module mod
Command Default
This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(8a)EW
12.1(19)EW
12.2(18)EW
15.1.0 SG
Examples The following example shows how to display switch-port information using the begin output modifier:
Switch# show interfaces switchport | include VLAN
Name: Fa5/6
Access Mode VLAN: 200 (VLAN0200)
Trunking Native Mode VLAN: 1 (default)
Trunking VLANs Enabled: ALL
Pruning VLANs Enabled: ALL
Switch#
The following example shows how to display switch-port information for module 1:
Switch# show interfaces switchport module 1
Name:Gi1/1
Switchport:Enabled
Administrative Mode:dynamic auto
Operational Mode:down
Administrative Trunking Encapsulation:negotiate
Negotiation of Trunking:On
Access Mode VLAN:1 (default)
Trunking Native Mode VLAN:1 (default)
Administrative private-vlan host-association:none
Administrative private-vlan mapping:none
Operational private-vlan:none
Trunking VLANs Enabled:ALL
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-756
show interfaces [interface-id] switchport [module mod]
(Optional) Interface ID for the physical port.
(Optional) Limits the display to interfaces on the specified module; valid values are
from 1 to 6.
Modification
This command was introduced on the Catalyst 4500 series switch.
Support for per-interface display.
Support for displaying the status of native VLAN tagging in the command output.
Support for PVLAN modes over EtherChannel. Modes include: private-vlan host,
private-vlan promiscuous, private-vlan trunk secondary, and private-vlan trunk
promiscuous.
Chapter 2
OL-30934-01