Cisco Catalyst 4500 Series Configuration Manual page 719

Chapter 2
show arp access-list
To display detailed information on an ARP access list, use the show arp command.
Syntax Description
This command has no arguments or keywords.
Command Default
This command has no default settings.
Command Modes EXEC
Command History Release
12.1(19)EW
Examples
The following example shows how to display the ARP ACL information for a switch:
Switch# show arp access-list
ARP access list rose
Related Commands Command
access-group mode
arp access-list
ip arp inspection filter vlan
show arp access-list
Modification
This command was introduced on the Catalyst 4500 series switch.
permit ip 10.101.1.1 0.0.0.255 mac any
permit ip 20.3.1.0 0.0.0.255 mac any
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Description
Specifies the override modes (for example, VACL overrides
PACL) and the non-override modes (for example, merge or strict
mode).
Defines an ARP access list or adds clauses at the end of a
predefined list.
Permits ARPs from hosts that are configured for static IP when
DAI is enabled, defines an ARP access list, and applies the access
list to a VLAN.
show arp access-list
2-671