Run The Design On The Host Computer - Xilinx KCU105 User Manual

Run the Design on the Host Computer

This section provides instructions to run the reference design on either a host computer
with Linux, or a host computer with Windows 7.
Run the Design on a Linux Host Computer
Setup
This section describes how to set up the reference design using the Linux drivers and the
Fedora 20 LiveDVD.
Figure 3-7 shows different boot stages of Fedora 20. After you reach the third screen,
shown in Figure
you run the Fedora operating system from the DVD.
If you want to install Fedora 20 on the hard drive connected to the host system, click
CAUTION!
the Install to Hard Drive option. BE CAREFUL!
X-Ref Target - Figure 3-7
Check for PCIe Devices
1. After the Fedora 20 OS boots, open a terminal and use lspci to see a list of PCIe devices
detected by the host computer:
$ lspci | grep Xilinx
The following is displayed:
04:00.0 Communications controller: Xilinx Corporation Device 8082
If the host computer does not detect the Xilinx PCIe Endpoint,
Note:
Xilinx device.
PCIe Streaming Data Plane TRD
UG920 (v2017.1) June 01, 2017
3-7, click the Try Fedora option, then click Close. It is recommended that
Figure 3-7: Fedora 20 Boot Stages
www.xilinx.com
Chapter 3:
This option erases any files on the hard disk!
lspci
Send Feedback
Bringing Up the Design
UG920_c3_09_042015
does not show a
22