Xilinx KCU105 User Manual page 12

Install Drivers
1. From Windows Explorer, navigate to the folder in which the reference design is
downloaded (<dir>\kcu105_axis_dataplane\software\windows) and run the
setup file with Administrator privileges as shown in
X-Ref Target - Figure 2-2
2. Click Next after the InstallShield Wizard opens.
3. Click Next to install to the default folder; or click Change to install to a different folder.
4. Click Install to begin driver installation.
5. A warning screen is displayed as the drivers are installed, because the drivers are not
signed by a trusted certificate authority yet. To install the drivers, ignore the warning
message and click Install this driver software anyway. This warning message pops up
two times. Repeat this step.
6. After installation is complete, click Finish to exit the InstallShield Wizard.
Set DIP Switches
Ensure that the DIP switches and jumpers on the KCU105 board are set to the factory
default settings as identified in the Kintex UltraScale FPGA KCU105 Evaluation Board User
Guide (UG917)
PCIe Streaming Data Plane TRD
UG920 (v2017.1) June 01, 2017
Figure 2-2: Run the Setup File with Administrator Privileges
[Ref 4].
www.xilinx.com
Chapter 2: Setup
Figure 2-2.
UG920_c2_02_040915
Send Feedback
12