Xilinx KCU105 User Manual page 73

8. A snapshot of the expected response for Ethernet IP settings is shown in
X-Ref Target - Figure 5-18
7. Ping each MAC IP
10.60.1.1 as opposed to 10.50.0.1 and 10.50.1.1 IP as shown in the ifconfig output. This
is because both the interfaces are supported on the same host and network address
translation (NAT) is used to set up the IP address to 10.60.0.1 and 10.60.1.1. This is done
during driver installation through scripts.
X-Ref Target - Figure 5-19
PCIe Streaming Data Plane TRD
UG920 (v2017.1) June 01, 2017
Chapter 5: Targeted Reference Design Details and Modifications
Figure 5-18: Ethernet IP Configuration Snapshot
(Figure 5-19). The IP addresses to be used for this are 10.60.0.1 and
Figure 5-19: Ethernet Ping Snapshot
www.xilinx.com
Figure
UG920_c5_18_121614
UG920_c5_19_121614
Send Feedback
5-18.
73