Chapter 3: Bringing Up The Design; Set The Host System To Boot From The Livedvd (Linux) - Xilinx KCU105 User Manual

Bringing Up the Design
This chapter describes how to bring up and test the targeted reference design.
Set the Host System to Boot from the LiveDVD
(Linux)
This section is only applicable to host computers running Linux. If running Windows 7,
Note:
proceed to Configure the FPGA, page
1. Power on the host system. Stop it during BIOS to select options to boot from a DVD
drive. BIOS options are entered by pressing DEL, F12, or F2 keys on most systems.
If an external power supply is used instead of the ATX power, the FPGA can be configured
Note:
first. Then power on the host system.
2. Place the Fedora 20 LiveDVD into the DVD drive.
3. Select the option to boot from DVD.
Complete the Configure the FPGA
the DVD.
PCIe Streaming Data Plane TRD
UG920 (v2017.1) June 01, 2017
16.
procedures before exiting the BIOS setup to boot from
www.xilinx.com
Chapter 3
15
Send Feedback