Attaching The Camera Hood Assembly - Cisco CTS-3010 Administration Manual

Managing Hardware Setup
Figure 9-9
Zoom ring
Tip Use the thumbscrew (or 0.9 mm Allen wrench) to unlock the focus ring.
b.
c.
d.
e.
f.
Remove the targets and place them in front of the left camera.
Step 6
Complete
Step 7
Remove the targets and place them in front of the right camera.
Step 8
Complete
Step 9

Attaching the Camera Hood Assembly

After you complete the camera adjustment, attach the camera hood assembly. See
Note Attach the top hood before attaching the bottom hood.
Cisco TelePresence System Release 1.6 Administration Guide
9-14
Location of Focus and Zoom Rings
Twist the focus ring clockwise until the red and green horizontal bars on the bottom of the screen
are reduced to very short lengths on the left.
Twist the focus ring counter-clockwise until the red and green bars extend all the way to the right.
Continue to twist the focus ring until the red and green bars are approximately the same length.
Make any additional adjustments you need to make to the zoom adjustments.
Occasionally, adjusting the focus can slightly change the zoom.
Click Hide Focus Targets, then click Done when you complete the adjustment.
Step 1 through Step 5
Step 1 through Step 5
Chapter 9
Focus ring
for the left camera.
for the right camera.
Troubleshooting the CTS 3010 and CTS 3210
Figure 9-10.
OL-13676-05