Cisco CTS-3010 Administration Manual page 284

Managing Hardware Setup
Step 9 Replace the camera cover onto the camera cluster, then tighten the cover release screws to secure the
cover to the camera.
Figure 7-81 Replacing the Camera Cover
Arranging the Seat Alignment Guides
Conference participants should be seated in an area that is completely within the field of view of one of
the three cameras. To ensure this requirement, Cisco provides you with Seat Alignment Guides. After
you set up the cameras, you place these guides on the table; these guides show the field of view for each
camera.
To place the seat alignment guides on the table, follow these steps:
Step 1 Using a supported Internet browser, log in to the Cisco TelePresence System administration GUI.
Select the correct table type by completing the following steps:
Step 2
Navigate to Troubleshooting > Hardware Setup
Step 3
Click the Cameras radio button.
Step 4
Click Start to display the image of the cameras in the displays.
Step 5
Cisco TelePresence System Release 1.6 Administration Guide
7-88
Cover
release
screws
Cover
release
screws
Chapter 7 Troubleshooting the CTS 1300
Cover
release
screws
OL-13676-04