Testing The Cts 3000 And Cts 3200 Cameras - Cisco CTS-3010 Administration Manual

Chapter 8 Troubleshooting the CTS 3000 and CTS 3200

Testing the CTS 3000 and CTS 3200 Cameras

The cameras are set up correctly when images are centered and in focus on the display screens and the
white balance has been configured. The hardware setup software provides a camera Auto Adjust feature
and a way to use targets to fine-tune the camera's focus.
The following sections describe how to set up the CTS 3000 and CTS 3200 cameras for testing:
•
•
•
•
•
•
•
•
Attaching the Camera Targets and Removing the Camera Cover
Two camera targets are provided with the Cisco TelePresence system:
•
•
To attach the targets, follow these steps:
Attach the large camera target to the table with the clamps matching the counterbore feature under the
Step 1
table.
Step 2 Center the target on the edge of the table and position it vertically with the clamps underneath the table
holding it tight. The target pattern should face the camera.
Step 3 Place the small camera target on the table.
Step 4 Remove the camera cover. See the
the removal and replacement directions.
Testing the Camera
To begin the camera testing process, follow these steps:
Step 1 Log in to the Cisco TelePresence System Administration window.
Step 2 Choose Troubleshooting > Hardware Setup.
Step 3 Click the Cameras radio button.
Step 4 Click Start to begin the camera test. You should see output from each camera in the appropriate camera
display area.
Step 5 Click Setup under the image of a display screen to begin adjustments for the camera focused on that
screen.
OL-13676-05
Attaching the Camera Targets and Removing the Camera Cover, page 8-7
Testing the Camera, page 8-7
Auto Adjusting the Camera, page 8-8
Aligning the Camera, page 8-8
Showing All Camera Targets, page 8-11
Focusing the Camera, page 8-11
Saving Your Settings, page 8-12
Attaching the Camera Hood Assembly, page 8-12
Large camera target
Smaller target
"Attaching the Camera Hood Assembly" section on page 8-12
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
to see
8-7