Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
If four or more of the six participants directly face the display, follow the procedure in the
the CTS 1300 for Use With a Long Straight Table, Wide Rectangular Table, or Long Racetrack table"
section on page 7-13
Configuring the CTS 1300 for Use With a Long Straight Table, Wide Rectangular Table, or Long Racetrack table
This section includes the procedures you perform to configure the CTS 1300 software and cameras for
use with a room that has a long straight table, wide rectangular table, or wide racetrack table, and
includes the following topics:
•
•
•
•
•
•
•
Positioning the Table and Starting the Calibration Procedure
To correctly position the table and configure the Cisco TelePresence software for use with the CTS 1300
cameras, follow these steps:
Position the table so that there is a minimum of 44 inches between the display and the front of the table,
Step 1
and make sure that the sides of the table are evenly positioned on each side of the CTS 1300, as shown
in the following examples:
•
•
•
Make sure that the farthest edge of the table is no farther than 110 inches away from the lower bezel of
Step 2
the display.
The table must be 28 to 32 inches high. 30 inches is the optimal height.
Note
OL-13676-04
Positioning the Table and Starting the Calibration Procedure, page 7-13
Calibrating the Center Camera, page 7-18
Calibrating the Right Camera, page 7-21
Calibrating the Left Camera, page 7-24
Focusing the Center Camera, page 7-27
Focusing the Right Camera, page 7-29
Focusing the Left Camera, page 7-30
Long, straight table,
Figure 7-7
Wide rectangular table,
Figure 7-8
Long racetrack table,
Figure 7-9
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
"Configuring
7-13
Advertisement
Table of Contents
Troubleshooting
