Configuring A Static Ip Address For Networks That Do Not Use Dhcp; Configuring A Static Ip Address Using The Cisco Telepresence System Gui - Cisco CTS-3010 Administration Manual

IP Settings
Table 3-1
Field or Button
DHCP Enabled:
Domain Name:
Use Static IP Address:
IP Address
Subnet Mask
Default Gateway
DNS Server 1 and 2

Configuring a Static IP Address for Networks That Do Not Use DHCP

If your network does not use DHCP, complete one of the following procedures to configure a static IP
address for your Cisco TelePresence system.
See the following sections to manage static IP addresses:
•
•
•

Configuring a Static IP Address Using the Cisco TelePresence System GUI

To configure a static IP address using the Cisco TelePresence system GUI, follow these steps.
Step 1 Connect a DHCP-enabled PC to the secondary camera port of the primary codec. This connection is
listed as the auxiliary network port in
Cisco TelePresence System Release 1.6 Administration Guide
3-6
IP Settings
Setting
Indicates whether Dynamic Host Configuration Protocol (DHCP) has
been enabled for the CTS primary codec. DHCP is enabled by default.
Indicates the domain name for the primary codec.
Indicates whether the CTS primary codec is configured to use a static IP
address. Static IP address is disabled by default.
IP address for the Cisco TelePresence system.
Subnet mask used for the IP address supplied.
Default gateway for the CTS primary codec.
IP addresses of the Domain Name System (DNS) servers.
Configuring a Static IP Address Using the Cisco TelePresence System GUI, page 3-6
Configuring a Static IP Address Using Command-Line Interface Commands, page 3-8
Command Example, page 3-9
Click the No radio button to update the following fields:
•
Domain Name
–
IP Address
–
Subnet Mask
–
Default Gateway
–
– DNS Server 1
– DNS Server 2
• Click the Yes radio button to update the following fields:
IP Address
–
Subnet Mask
–
Figure 3-4.
Chapter 3 Configuring the Cisco TelePresence System
OL-13676-05