Table of Contents
Advertisement
IP Settings
Step 9
Enter a static IP address, subnet mask, and IP gateway for your system into the fields. Optionally, enter
DNS server(s) and the network domain name. Your system saves the changes and automatically restarts.
Configuring a Static IP Address Using Command-Line Interface Commands
To configure a static IP address using command-line commands, follow these steps.
Connect a DHCP-enabled PC to the secondary camera port of the primary codec. This connection is
Step 1
listed as the auxiliary network port in
Figure 3-5
Auxiliary Network Port Location
Determine the IP address that the Cisco TelePresence system provided for your session.
Step 2
For Windows-based systems, you can see the IP address in the Support tab in the Local Area Connection
Tip
Status window.
Step 3
Using Secure Shell SSH or another secure client program, start a CLI session with the TelePresence
system using the IP address xxx.xxx.xxx.1,
Where:
xxx.xxx.xxx is the IP address that Cisco TelePresence provided for your session.
For example, if your determine that the Cisco Telepresence system provided an IP address of 10.1.0.2,
enter the address 10.1.0.1.
By default, the username is admin and the password is cisco.
Enter the following command to configure a static network IP address:
Step 4
Cisco TelePresence System Release 1.6 Administration Guide
3-8
Chapter 3
Figure
3-4.
Configuring the Cisco TelePresence System
OL-13676-05
Advertisement
Table of Contents
Troubleshooting
