Setting Up CTS Components
Step 5
Adjust the focus on the camera by performing the following steps:
a.
Figure 9-10
b.
c.
d.
e.
f.
Remove the targets and place them in front of the left camera.
Step 6
Complete
Step 7
Remove the targets and place them in front of the right camera.
Step 8
Complete
Step 9
Attaching the Camera Hood Assembly
After you complete the camera adjustment, attach the camera hood assembly. See
Attach the top hood before attaching the bottom hood.
Note
Cisco TelePresence System 3000
9-14
Loosen the thumbscrew for the lens focus ring. The ring is labeled "N-8".
Location of Focus and Zoom Rings
Zoom ring
Use the thumbscrew (or 0.9 mm Allen wrench) to unlock the focus ring.
Twist the focus ring clockwise until the red and green horizontal bars on the bottom of the screen
are reduced to very short lengths on the left.
Twist the focus ring counter-clockwise until the red and green bars extend all the way to the right.
Continue to twist the focus ring until the red and green bars are approximately the same length.
Make any additional adjustments you need to make to the zoom adjustments.
Occasionally, adjusting the focus can slightly change the zoom.
Click Hide Focus Targets, then click Done when you complete the adjustment.
Step 1
through
Step 5
Step 1
through
Step 5
for the left camera.
for the right camera.
Chapter 9
First-Time Setup
Focus ring
Figure
9-11.
OL-14521-01