Table of Contents
Advertisement
Managing Hardware Setup
•
Use the top two screws for left and right adjustment.
The lower screw for up and down adjustment.
•
The screws in the middle for adjustments on the horizontal plane (rotational).
•
Figure 7-41
Side to side
adjust screw
Step 6
Adjust the camera zoom by completing the following steps:
a.
Loosen the thumbscrew for the zoom ring on the camera lens.
Note
Adjust the camera zoom so that the black curved line on the left of the target touches the left edge
b.
of the display screen, as shown in
Note
c.
After you adjust the zoom, make any required adjustments to the focus with the focus ring.
Cisco TelePresence System Release 1.6 Administration Guide
7-44
Camera Adjustment Screws
Left
adjust
screw
Up/down
adjust
screw
The zoom ring is labeled "W-T."
Because of the position of the target, the target appears smaller and not parallel to the camera.
This view is normal. Participants will appear lifelike after you complete the testing procedure.
Right
adjust
screw
Up/down
adjust
screw
Figure
7-42.
Chapter 7
Troubleshooting the CTS 1300
Side to side
adjust screw
OL-13676-04
Advertisement
Table of Contents
Troubleshooting
