Testing Presentation Devices - Cisco CTS-3010 Administration Manual

Managing Hardware Setup

Testing Presentation Devices

The output for presentations is handled by projectors, or LCDs. Input to the projector can be delivered
through a Video Graphics Array (VGA) input device (such as a laptop computer) or through a document
camera.
Note You should run this test only if you have presentation display devices installed.
Table 8-6
Table 8-6 Supported Presentation Devices
Presentation Device
Projector
Document Camera
Auxiliary Display
The projector is set up successfully when the test pattern is displayed on the projection surface in the
meeting room while running the test.
Tip When troubleshooting presentation devices, start with the projector test pattern to see if the projector is
set up correctly and then proceed through VGA and document camera input tests as necessary.
Use the information in the following sections to test presentation devices:
•
•
•
•
•
•
•
Cisco TelePresence System Release 1.6 Administration Guide
8-24
contains supported presentation devices listed by system.
Included in Cisco TelePresence System
• CTS 3000
CTS 3200
•
CTS 3200
•
—
Checking the Test Pattern, page 8-25
Checking the VGA, page 8-26
Checking the Document Camera, page 8-26
Testing the Projector, page 8-26
Troubleshooting Presentation Devices, page 8-34
Important Notes About Presentation Displays, page 8-36
Related Information, page 8-36
Chapter 8 Troubleshooting the CTS 3000 and CTS 3200
Optional in Cisco TelePresence System
—
CTS 3000
•
• CTS 3000
• CTS 3200
OL-13676-05