Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
Step 5
Click Show Camera Target. Red targets appear on the center display.
Focus the center camera by completing the following steps:
Step 6
Loosen the focus ring thumbscrew on the lens of the center camera.
a.
Rotate the focus ring until the black plus sign (+) on the target is clearly in focus.
b.
Note
Figure 7-32
Zoom ring
Step 7
Adjust the camera mounting plate to center the red plus sign (+) on the display inside the black plus sign
(+) on the target.
The screws that you use to adjust the camera are shown in
•
Use the top two screws for left and right adjustment.
•
The lower screw for up and down adjustment.
•
The screws in the middle for adjustments on the horizontal plane (rotational).
OL-13676-04
The camera lens has two adjustment rings, one for focus and one for zoom, as shown in
Figure
7-32. The focus ring is the one that is nearest to the wall.
Location of Focus and Zoom Ring
Focus ring
Figure
7-33. Use a 2.5 mm Allen wrench.
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
7-37
Advertisement
Table of Contents
Troubleshooting
