Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
Figure 7-5
Side to side
adjust screw
Attaching the Large Camera Target to the Easel
To unpack and build the easel and large camera target, follow these steps:
Remove the easel, large camera target, and small camera target from their packaging.
Step 1
Unlock and slide the telescoping legs of the easel until the legs are at their full height.
Step 2
Separate the three legs.
Step 3
Raise the front legs until they are 29 inches (74 cm) high.
Step 4
Raise the rear leg until it is 31 inches (79 cm) high.
Step 5
Lock the legs into place using the leg locks.
Step 6
Step 7
Attach the large camera target to the clip on top of the easel.
Step 8
Raise the target supports on the front legs until they touch the lower part of the large camera target.
Step 9
Raise and lower the front legs until the bottom of the camera target is 32 inches above the ground.
Figure 7-6
OL-13676-04
Camera Rotational Adjustment Screws
Left
adjust
screw
Up/down
adjust
screw
shows the completed camera target and easel.
Right
adjust
screw
Up/down
adjust
screw
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
Side to side
adjust screw
7-11
Advertisement
Table of Contents
Troubleshooting
