Table of Contents
Advertisement
Managing Hardware Setup
Table 4-7
Troubleshooting Presentation Devices
Problem
System Status window shows
unexpected Document Camera
status.
Tip
Presentation devices automatically shut off when there is no longer a video signal to that presentation device. An
on-screen timer counts down the remaining time to shut-down. The amount of time that it takes a device to shut down
depends on your Cisco Unified CM configuration. Most CTS devices that support
after the video signal is removed. Devices on the CTS 3000 and CTS 3200 series that have black boxes associated
with the auxiliary control take 5 minutes to shut down. See the Product Specific Configuration Layout section of the
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
information about controlling presentation devices and associated displays.
Related Information
For more information about setting up and testing presentation devices, see the
System 500 Assembly, Use & Care, and Field Replacement Unit
For more system troubleshooting information, see the
Guide
Testing Other Devices
Use the Other Devices Tab to check the following additional devices:
•
•
•
•
•
•
Auxiliary Control Unit
The auxiliary control unit (ACU) controls the individual light units surrounding the displays in CTS
conference rooms, which allows the CTS to receive projector or alternate display status information and
restore projector or alternate display defaults.
To test the ACU, follow these steps:
Step 1
Log in to the Cisco TelePresence System Administration window.
Choose Troubleshooting > Hardware Setup.
Step 2
Click the Other Devices radio button.
Step 3
Cisco TelePresence System Release 1.6 Administration Guide
4-28
Possible Cause
Document camera settings may
need to be adjusted in
Cisco Unified CM.
on Cisco.com.
Auxiliary Control Unit, page 4-28
LEDs, page 4-29
Shroud Light, page 4-29
Digital Media Player, page 4-30
Troubleshooting Other Devices, page 4-31
Related Information, page 4-32
Chapter 4
Possible Solution
Cisco recommends setting the Digital Visual Interface
(DVI) resolution to XGA/60 at 1024 x 768/60 Hz. See
the Optional Hardware section of the
Communications Manager Configuration Guide for the
Cisco TelePresence System
PiP
shut down in 10 to 15 seconds
Guide.
Cisco TelePresence System Troubleshooting
Troubleshooting the CTS 500
Cisco Unified
for more information.
for more
Cisco TelePresence
OL-13676-05
Advertisement
Table of Contents
Troubleshooting
