Attaching The Camera Hood Assembly - Cisco 3200 Use And Care Manual

Chapter 10 First-Time Setup
Figure 10-11 Positioning the Small and Large Targets for the Second Row
Large target
d.
Step 7 Remove the targets and place them in front of the left camera.
Step 8 Complete
Step 9 Remove the targets and place them in front of the right camera.
Step 10 Complete

Attaching the Camera Hood Assembly

After you complete the camera adjustment, attach the camera hood assembly. See
Attach the top hood before attaching the bottom hood.
Note
Caution Do not overtighten the screws, or use a power screwdriver to tighten the screws. The recommended
torque for the screws is 0.8N.m (7 inch-pounds).
In addition, make sure that you use screws of the correct length (20 mm). Overtightening the screws, or
using a screw that is too long, can cause the plastic hoods to break.
OL-14521-01
10 ft
Make sure that the targets are still be aligned within the green and red boxes on the display. See
Figure 10-9 for more information.
Step 1 through Step 6
Step 1 through Step 6
Small target
for the left camera.
for the right camera.
Setting Up CTS Components
10 ft
Figure 10-12.
Cisco TelePresence System 3200
10-15