Verifying Cts 1300 Light Function; Testing Other Devices; Auxiliary Control Unit - Cisco CTS-3010 Administration Manual

Managing Hardware Setup

Testing Other Devices

Use the Other Devices Tab to check the following additional devices:
•
•
•
•
•

Auxiliary Control Unit

The auxiliary control unit (ACU) controls the individual light units surrounding the displays in CTS
conference rooms and enables the CTS to get more complete projector status information and to restores
projector defaults.
To test the ACU, follow these steps:
Log in to the Cisco TelePresence System Administration window.
Step 1
Step 2 Choose Troubleshooting > Hardware Setup.
Step 3 Click the Other Devices radio button.
Step 4 Click Start in the Testing box. The Auxiliary Control Unit (Current Status) is displayed. Individual light
units correspond to the five port numbers of the Auxiliary Control Unit, Ports 1 through 5.
a.
b.
c.
d.
e.
Click Stop to end the test.
Step 5

Verifying CTS 1300 Light Function

Each CTS 1300 has a built-in light fixture. This troubleshooting feature lets you see or change the status
of the light.
To test the light fixture, perform the following procedure:
Step 1 Navigate to Troubleshooting > Hardware Setup.
Step 2 Click the Other Devices radio button.
Step 3 Click the Light tab.
Cisco TelePresence System Release 1.6 Administration Guide
7-102
Auxiliary Control Unit, page 7-102
Verifying CTS 1300 Light Function, page 7-102
Digital Media Player, page 7-103
Troubleshooting Other Devices, page 7-104
Related Information, page 7-104
Check a box to select a specific port number.
Or
Click Select All to select all ports (and all light units) or Select None.
Click the Refresh On/Off Status button to update the on/off status of each port.
Click the Turn Selected Lights On/Off to test the selected light unit(s).
Click the Reset Auxiliary Control Unit to power cycle the Auxiliary Control Unit.
Chapter 7 Troubleshooting the CTS 1300
OL-13676-04