Table of Contents
Advertisement
Managing Hardware Setup
Related Information
For more information about setting up and testing speakers, see the
Assembly, Use & Care, and Field Replacement Unit
For more system troubleshooting information, see the
Guide
Testing Microphones
The microphones are set up successfully when each microphone registers sound. You must supply sound
at each microphone to complete this test.
The number of audio meters that are shown on the test screen is determined by the number of
Note
microphones that have been configured in Cisco Unified Communications Manager (Cisco Unified CM)
and the version of Cisco Unified CM that you are running.
The Microphone Troubleshooting screen displays the number of microphones available for testing:
•
Testing Microphones
Go to the following sections to test microphones:
•
•
•
Testing Microphones on the CTS 1000
To test microphones on the CTS 1000, follow these steps:
Step 1
Log in to the Cisco TelePresence System Administration window.
Step 2
Choose Troubleshooting > Hardware Setup.
Click the Microphones radio button.
Step 3
Click Start in the Testing box to begin the test. The Microphone Calibration button is activated.
Step 4
Lightly tap each microphone and watch the audio meter on the corresponding display screen to see that
Step 5
sound registers.
Click Stop to end the test.
Step 6
Cisco TelePresence System Release 1.6 Administration Guide
5-18
on Cisco.com.
CTS 1000—1 microphone with a single audio meter displayed on a single test screen.
Testing Microphones on the CTS 1000, page 5-18
Troubleshooting Microphones, page 5-19
Related Information, page 5-20
Chapter 5
Troubleshooting the CTS 1000
Cisco TelePresence System 1000
Guide.
Cisco TelePresence System Troubleshooting
OL-13676-05
Advertisement
Table of Contents
Troubleshooting
