Table of Contents
Advertisement
First Time Setup
Step 7
In the URL field, type the IP address that you obtained in
the Cisco TelePresence System Administration application.
If you need to obtain the IP address, complete the following steps:
Note
On the Cisco Unified IP phone, locate "Manual" at the bottom of the screen and press the Manual
a.
soft key.
Note
Locate "Info" at the bottom of the screen and press the Info soft key.
b.
Scroll down to the IP Address listing and copy the address.
c.
Step 8
Log in to the system by entering the following information:
•
Username: admin (case sensitive)
Password: cisco (case sensitive)
•
You can change your password in Cisco Unified CM. See the
Note
Configuration Guide for the Cisco TelePresence
Step 9
Click Login. The Device Information window appears, as shown in
Figure 3-3
Note
See the
CTS firmware releases.
Cisco TelePresence System Release 1.6 Administration Guide
3-4
If you cannot locate the Manual button, proceed to Step
Device Information Screen
"Upgrading CTS Codec Firmware" section on page 3-19
Chapter 3
Configuring the Cisco TelePresence System
Step 3
and press Enter. The browser launches
b.
Cisco Unified Communications Manager
System.
Figure
for information about upgrading to new
3-3.
OL-13676-05
Advertisement
Table of Contents
Troubleshooting
