Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
Figure 7-9
Step 3
Make sure that the camera assembly is level by completing the steps in the
and Leveling the Cameras" section on page
Step 4
Build the easel, and attach the large camera target to the easel, by completing the steps in the
the Large Camera Target to the Easel" section on page
32 inches above the ground.
Step 5
Log in to the Cisco TelePresence System Administration window.
Step 6
Select the table type by completing the following steps:
a.
Choose Troubleshooting > Hardware Setup.
b.
Click the Configuration radio button. The table configuration window appears, as shown in
Figure
OL-13676-04
Long Racetrack Table Positioning
A
10 feet
44 inches
minimum
30 inches
7-2.
A=B
B
6 feet minimum,
12 feet maximum,
8 feet recommended
7-8.
7-11, making sure that the bottom of the target is
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
"Removing the Camera Cover
"Attaching
7-15
Advertisement
Table of Contents
Troubleshooting
