Table of Contents
Advertisement
Managing Hardware Setup
Figure 7-82
Measuring and Installing the Seat Alignment Guides
Field of view
center camera
Field of view
left camera
12
18 inches
(46 cm)
1
Place another piece of tape 18 inches (46 cm) from the edge of the table where the participants sit to
Step 8
form a tape cross on the table.
Remove the seat alignment guides and (if required) anchors from their packaging in carton 14.
Step 9
Place the seat alignment guides on each of the crosses on the table. See
Step 10
information.
Arrange the seat alignment guides so that the line on top of the guides point directly toward the camera.
Step 11
Fasten the guides to the table using one of the following methods:
Step 12
•
•
Cisco TelePresence System Release 1.6 Administration Guide
7-90
10
11
18 inches
(46 cm)
2
3
Remove the adhesive backing from the underside of the guide and stick it to the table, making sure
that the line on the guide points directly at the camera.
Attach the seat alignment guide anchor to the table, and place the guide on the anchor, by completing
the following steps:
Using a 1/4-inch drill bit, drill a 1.125 inch deep hole into the center of each tape cross.
a.
Remove the tape.
b.
Screw the seat alignment guide anchor into the hole that you drilled, using the key that is
c.
included with the anchor.
Field of view
right camera
9
8
7
18 inches
(46 cm)
4
5
6
Chapter 7
Troubleshooting the CTS 1300
18 inches
(46 cm)
Figure 7-82
for more
OL-13676-04
Advertisement
Table of Contents
Troubleshooting
