Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
Figure 7-57
Tighten the thumbscrews for the zoom and focus rings.
Step 7
Click Hide Camera Targets.
Step 8
Click the Setup button, then click the Auto Adjust button.
Step 9
The auto adjust procedure completes. This procedure takes several seconds.
Note
If there is insufficient light, the auto adjust procedure terminates; in this case, add more light to the room
and repeat the auto adjust procedure.
Click Done to complete the procedure.
Step 10
Calibrating the Left Camera
To adjust the zoom and perform initial focus adjustment for the left camera, complete the steps in the
following procedure.
Note
If you logged out of the GUI, you must re-select the correct table type after you log in; otherwise, you
could configure your system for the incorrect table type. To select the correct table type, complete
in the
Move the large camera target 86 inches (218 cm) from the display, and 18 inches (46 cm) overhanging
Step 1
the table on the left side. See
Position the target to that it is parallel with the wall.
Step 2
In the Cisco TelePresence administrative GUI, click the Left radio button.
Step 3
Click Show Camera Target.
Step 4
OL-13676-04
Adjusting the Camera Zoom
"Positioning the Table and Starting the Calibration Procedure" section on page
Figure 7-54
for the location of the left target.
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
Step 5
7-51.
7-61
Advertisement
Table of Contents
Troubleshooting
