Table of Contents
Advertisement
Cisco Unified Communications Manager Settings
Administrative VLAN ID
The CTS must have a VLAN membership ID before it can proceed with a DHCP request for an IP
address.
To view or configure the administrative VLAN ID, follow these steps:
Choose Configuration > Network Settings.
Step 1
Enter an administrative VLAN ID for Cisco TelePresence in this field.
Step 2
Note
The Apply and Reset buttons become active when a value is entered in this field.
Step 3
Click Apply to register a new or modified setting.
Step 4
Click Reset to restore the administrative VLAN ID setting displayed when you opened this window.
Syslog Address
This field shows the display-only syslog address that is standard for networks with a Cisco Unified IP
phone.
Cisco Unified Communications Manager Settings
To specify TFTP server locations and view a list of available settings for this Cisco TelePresence system,
follow these steps:
Choose Configuration > Cisco Unified Communications Manager Settings.
Step 1
Configure Cisco Unified CM Settings using the information in
Step 2
Table 3-2
Field
Use Configuration TFTP Server
TFTP Server 1 through 5
Cisco Unified Communications
Manager 1 through 5
Cisco TelePresence System Release 1.6 Administration Guide
3-10
Cisco Unified Communications Manager Settings
Settings
Click Automatic to set the default condition, which is that the
•
TFTP server will reply to DHCP requests for option 150, or for
a list of TFTP servers that indicate to endpoints in the network
where to find Cisco Unified CM configuration files.
•
Click Specify to manually supply IP addresses of TFTP servers
in the interactive fields provided.
Click Specify at Use Configuration TFTP Server to activate
interactive fields that are provided for entering TFTP server IP
addresses.
Display-only report that shows the names of up to five
Cisco Unified Communications Managers.
Chapter 3
Configuring the Cisco TelePresence System
Table
3-2.
OL-13676-05
Advertisement
Table of Contents
Troubleshooting
