Table of Contents
Advertisement
Chapter 9
Troubleshooting the CTS 3010 and CTS 3210
Figure 9-7
Step 3
In the Cisco TelePresence Administrative GUI, click Setup, then click Show Focus Target.
Step 4
Adjust the small target so that the red box encloses the upper patterns on the large target and the green
box encloses the patterns on the small target.
Figure 9-8
Positioning the Small and Large Targets
Large
target
Small
target
Red and green
horizontal bars
Adjust the focus on the camera by performing the following steps:
Step 5
a.
OL-13676-05
Arranging the Small and Large Targets
Large target
Loosen the thumbscrew for the lens focus ring. The ring is labeled "N-8".
5 ft
Small target
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
10 ft
Red
rectangle
Green
rectangle
9-13
Advertisement
Table of Contents
Troubleshooting
