Table of Contents
Advertisement
Managing Hardware Setup
Figure 7-10
Click the Start button to start testing.
c.
Select the type of table you have from the drop-down menu:
d.
–
–
–
e.
Click Apply.
Note
If you log out of the Cisco TelePresence Administration interface at any time during the camera testing
procedure, you must re-select the table type.
Step 7
Choose Troubleshooting > Hardware Setup.
Step 8
Click the Cameras radio button. The Camera testing page appears.
Step 9
Click Start to start the camera test.
Step 10
Click Show Camera Target. The camera target menu appears, as shown in
Cisco TelePresence System Release 1.6 Administration Guide
7-16
Table Configuration Menu
Long Straight Table
Wide Rectangular Table
Long Racetrack table
Chapter 7
Troubleshooting the CTS 1300
Figure
7-11.
OL-13676-04
Advertisement
Table of Contents
Troubleshooting
