Table of Contents
Advertisement
Managing Hardware Setup
Related Information
For more information about setting up and testing displays, see the
Assembly, Use & Care, and Field Replacement Unit
For more system troubleshooting information, see the
Guide
Testing Cameras
The cameras are set up successfully when images are centered and in focus on the display screens and
the white balance has been configured. The hardware setup software provides a camera Auto Adjust
feature and a way to use targets to fine-tune the camera's focus.
You must use the camera Auto Adjust feature before you can auto focus the camera. See the
Note
Camera" section on page
Use the information in the following sections to test and troubleshoot the camera for your system:
•
•
•
•
The camera hood comes off. It should be removed and left off until these procedures are complete.
Note
Testing the CTS 1000 Camera
The following sections describe how to set up the CTS 1000 camera for testing:
•
•
•
•
•
•
•
Cisco TelePresence System Release 1.6 Administration Guide
5-6
on Cisco.com.
5-11.
Testing the CTS 1000 Camera, page 5-6
Understanding Camera Setup Choices for Room Lighting, page 5-15
Troubleshooting Cameras, page 5-16
Related Information, page 5-16
Removing the Camera Hood, page 5-7
Assembling and Setting Up the Camera Targets, page 5-7
Aligning the Camera, page 5-9
Setting the Field Depth, page 5-13
Calibrating the CTS 1000 Camera, page 5-14
Saving Your Settings, page 5-15
Attaching the Camera Hood, page 5-15
Chapter 5
Troubleshooting the CTS 1000
Cisco TelePresence System 1000
Guide.
Cisco TelePresence System Troubleshooting
"Tuning the
OL-13676-05
Advertisement
Table of Contents
Troubleshooting
