Table of Contents
Advertisement
Chapter 4
Troubleshooting the CTS 500
Tip
If you have a pedestal stand-mounted CTS 500 and applied the height sticker, you can use it to choose
an approximate height. For more information about the height sticker, see the
Stand-Mounted CTS 500"
Field Replaceable Unit
Position the easel so the black plus sign (+) of the target is in the same position as the red plus sign
Step 9
(+) on the display.
Tip
You can raise and lower the large target by adjusting the legs of the easel or move the target slightly from
side to side. However, do not move the easel from the position that the user will occupy. If possible, move
the camera to accommodate the position of the easel.
Figure 4-6
Figure 4-6
Camera Adjustment
Note curved
lines touching
screen border
Loosen the thumbscrew on the camera and twist the zoom ring on the lens until the curved lines on the
Step 10
left and right are just touching the left and right borders of the screen. Make sure the black plus sign
(+) is still in the same position as the red plus sign (+). Tighten the thumbscrew when the adjustment is
complete.
See
Step 11
Click Remove Camera Target to stop the test.
OL-13676-05
chapter in the
Guide.
shows a camera correctly adjusted.
Figure 4-6
for an example of correct zoom adjustment.
Cisco TelePresence System 500 Assembly, Use & Care, and
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
"Assembling a Pedestal
Green
rectangle
Red plus
sign within
black cross
4-11
Advertisement
Table of Contents
Troubleshooting
