Table of Contents
Advertisement
Managing Hardware Setup
Figure 4-3
Large
target
Easel
Raise or lower the CTS 500 so that the green rectangle that displays on the screen is at the approximate
Step 8
eye level of the CTS 500 user.
If you have a wall-mounted CTS 500, skip this step.
Note
Use the following guidelines when raising and lowering the stand (see
•
Do not grasp the light reflector, or any part of the CTS-500 but the monitor.
Use two hands.
•
•
Do not lift using only one side.
•
Apply equal pressure from each side.
Cisco TelePresence System Release 1.6 Administration Guide
4-8
Camera Target Placement
5 ft
(1.5 m)
Chapter 4
Troubleshooting the CTS 500
Height
adjustment
knob
Figure 4-4
and
Figure
4-5):
OL-13676-05
Advertisement
Table of Contents
Troubleshooting
