Table of Contents
Advertisement
Managing Hardware Setup
Figure 7-70
Adjusting the Camera Zoom
Note curved
lines touching
screen border
Tighten the thumbscrews for the zoom and focus rings.
Step 10
Click Hide Camera Targets.
Step 11
Click the Setup button, then click the Auto Adjust button.
Step 12
The auto adjust procedure completes. This procedure takes several seconds.
Note
If there is sufficient light for the system to operate, the gain will be greater than 1 and less than 7 and
the process completes normally. If there is insufficient light, the auto adjust procedure terminates; in this
case, add more light to the room to bring the gain value below 7. Then, repeat the auto adjust procedure.
Click Done.
Step 13
Mark the edges of the large camera target on the table with non-marking tape.
Step 14
Use these marks to determine the edge of the target when you calibrate and configure the left and right
cameras.
Calibrating the Right Camera
To adjust and focus the right camera, complete the steps in the following procedure.
If you logged out of the GUI, you must re-select the correct table type after you log in; otherwise, you
Note
could configure your system for the incorrect table type. To select the correct table type, complete
in the
The directions left and right refer to the assembly as you face the display.
Note
Move the large camera target 86 inches (218 cm) from the display, and 18 inches (46 cm) overhanging
Step 1
the table on the right side.
Cisco TelePresence System Release 1.6 Administration Guide
7-76
"Positioning the Table and Starting the Calibration Procedure" section on page
Chapter 7
Troubleshooting the CTS 1300
Red plus
sign within
black cross
7-51.
OL-13676-04
Step 5
Advertisement
Table of Contents
Troubleshooting
