Cisco CTS-3010 Administration Manual page 66

System Settings
Table 3-5
Field
System Type
Days Display Not Active
Display On Time
Display On Duration
Note
NTP Servers
NTP Server 1-5
Use Cisco Unified CM to make changes to the system settings. See the
Step 3
Manager Configuration Guide for the Cisco TelePresence System
Cisco TelePresence System Release 1.6 Administration Guide
3-16
System Settings (continued)
Description or Setting
Identifies the CTS model. Choose from the following:
Cisco TelePresence 500
•
Cisco TelePresence 1000
•
• Cisco TelePresence 1100
Cisco TelePresence 1300
•
• Cisco TelePresence 3000
• Cisco TelePresence 3010
• Cisco TelePresence 3200
• Cisco TelePresence 3210
Note
Specifies the days of the week that the Cisco TelePresence system display
remains off by default. Choose Monday through Sunday. Default is
Sunday and Saturday.
Specifies the time of day that the Cisco TelePresence system display(s)
will remain on after being turned on, if CCM is configured. Times are
displayed in a 24-hour format where 00:00 indicates 12:00 midnight and
23:59 indicates 11:59 pm. Default is 07:30.
If you clear the default value so that the field is blank, the display(s) will
turn off after the completion of each call.
Specifies the length of time the Cisco TelePresence system display(s) will
remain on if a "Display On Time" value is defined. Times are displayed in
a 24-hour format, where 1:30 indicates one hour and thirty minutes; the
maximum value is 24:00 (24 hours). Default is 10:30.
If you clear the default value so that the field is blank, then the display will
turn off at 11:59 pm.
If your version of Cisco Unified CM does not allow you to configure values for Days Display
Not Active, Display On Time or Display On Duration, the system uses the default values for
these features.
Network Time Protocol (NTP) is used to synchronize the clocks on
Cisco IP telephony servers with an external network time server that uses
NTP. You can have up to five IP addresses for Network Time Protocol
servers.
Note
Chapter 3
You must select the CTS device type specifically to upgrade to
CTS Software Release 1.6.0 and later releases.
NTP must be configured properly to ensure that calendar events
appear as expected.
Configuring the Cisco TelePresence System
Cisco Unified Communications
for more information.
OL-13676-05