Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
Note
Figure 7-73
Step 7
Tighten the thumbscrews for the zoom and focus rings.
Step 8
Click Hide Camera Targets.
Step 9
Click the Setup button, then click the Auto Adjust button.
The auto adjust procedure completes. This procedure takes several seconds.
If there is insufficient light, the auto adjust procedure terminates; in this case, add more light to the room
Note
and repeat the auto adjust procedure.
Step 10
Click Done to complete the procedure.
Calibrating the Left Camera
To adjust the zoom and perform initial focus adjustment for the left camera, complete the steps in the
following procedure.
If you logged out of the GUI, you must re-select the correct table type after you log in; otherwise, you
Note
could configure your system for the incorrect table type. To select the correct table type, complete
in the
Step 1
Move the large camera target 86 inches (218 cm) from the display, and 18 inches (46 cm) overhanging
the table on the left side.
OL-13676-04
Because of the position of the target, the target appears smaller and not parallel to the camera.
This view is normal. Participants will appear lifelike after you complete the first-time setup
procedure.
Adjusting the Camera Zoom
"Positioning the Table and Starting the Calibration Procedure" section on page
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
Step 5
7-51.
7-79
Advertisement
Table of Contents
Troubleshooting
